Zinubel device and application

Novice craftsmen, as well as those who want to achieve serious success, definitely need to know more about the working tool. It is also worth understanding such a topic as the device and application of the tsinubel. And first you need to understand what kind of device it is.

Having even turned to popular dictionaries (or if you ask professionals), it is not difficult to find that the tsinubel is one of the types of plane.

The device is not used by itself, but in conjunction with other types of planers. With the help of a zinubel, you can give the workpiece the proper degree of roughness. It also forms shallow tracks at the points of contact of the parts.

The main purpose of using a zinubel is to level boards and various slabs. Later, they can be easily glued together. Thanks to the cinubel, you can easily eliminate:

• bully;

• curliness;

• knotty.

This tool is also suitable for working with plywood. Then it can be pasted over with veneer. The result is a superior quality finish. With sequential planing of an untreated board along the grain and across them, it is possible to eliminate a maximum of irregularities. Important: when passing with a zinubel, medium-sized shafts on the surface are inevitably obtained.

All the possibilities that a zinubel gives are due to the use of a special knife. But this cutting element must be clearly exposed. The blade protrudes slightly, forming a slight depression. That is why "shafts" appear. By default, the zinubel knife is placed at an angle of 70-80 degrees in relation to the surface.

The cutting angle at the Zinubel is close to the perpendicular. The peculiarities of the action of this tool make it possible to use it even for working with especially hard rocks. Curliness will not pose any serious problem. The only Zinubel knife that even works with mahogany and ebony has a unique cutting edge. In the area opposite to the chamfer, it is covered with a medium-sized notch. As a result, the cutting edge appears to be serrated. The tooth pitch can vary greatly:

• small - 0.75;

• medium zinubel - 1;

• large tool - 1.25.

This device is usually referred to as flat planing planes. Experts note that the cut angle for most production models is 80 degrees. When the teeth run over the surface, they remove very narrow (0.8 to 1 mm) chips. Such processing, leading to the appearance of a corrugated surface, rather resembles not planing, but scratching the material.

In order to bring the wooden blank to perfection, after passing it with the cinubel, it is additionally cleaned with a cycle. If you change a special knife in the tool for a standard one, it will be able to replace the grinder. The block at the cinubel is shortened and narrowed.

It is believed that the use of a zinubel is as gentle as possible. The combination of the grooved surface with the raised pile increases the traction characteristics. Therefore, gluing becomes much more effective. To use in grinding mode, you need to change the knife on the Zinubel. Instead of the standard tool for this, they put a double blade with a chip breaker on the edge.

The blade is positioned at a 50 degree angle to the sole. In this case, you can:

• scold badass;

• remove irregularities;

• smooth the ends;

• achieve perfect alignment of straight sections.

In the next video, you can learn more about this type of tool.