How to get rid of raspberries?
Raspberries are one of the hardiest shrubs, which can make it difficult to remove from your garden. Since the bushes spread easily, it will take a lot of effort to get rid of them. Remove the entire bush, including the roots, to prevent re-germination of the plant.
How to remove bushes?
Getting rid of raspberries in your garden is not as easy as it might seem at first glance. It is especially difficult to get rid of wild berry thickets forever.
Cut off the branches of the raspberry bush with a pair of pruning shears. Cut off all the shoots until only a stump of the bush remains. Place the branches in a trash can and discard them to prevent the berry from re-emerging and spreading to other parts of the yard.
It is also worth protecting the area where the shrub grew. For this, slate or sheets of iron are used. The material is dug into the ground to a depth of 40 centimeters.
If there are gaps, the roots will easily break through them.
At the second stage, weeding of the area around is carried out. Use a toothed tool to pry the root debris out of the soil. The soil is dug up several times during the spring and summer, and once in the fall before the first frosts.
How do I remove roots?
To completely remove the raspberry from the garden, it is necessary to uproot all the roots from the ground. Use a shovel to cut a circle around the stump of the raspberry bush. Dig up and remove any roots you can get. If left in the ground, half will rot and others may sprout.
It is better to remove the roots with a special device for uprooting. The hand tool can only be used for thin shrubs.
Typically, such a unit has in its design:
-
rack;
-
lever arm;
-
support platform;
-
capture.
You can use a bayonet shovel, which can easily chop off rhizomes in the ground.
It is possible to get rid of raspberries on average in a year. If you plant a site with siderates, they will displace the shoots.
How to prevent reappearance?
To prevent raspberries from growing on your site again, you need to follow simple instructions.
-
When the bushes are cut and the rhizomes are pulled out, the soil is treated with Roundup in the fall. You can spray it on young shoots that have recently emerged from root debris.
-
All activities for digging and cultivating the land are repeated in the spring.
-
Digging of the raspberry tree takes place to the depth of the shovel. At this point, you can take out and throw out the remaining roots.
-
Be sure to keep or re-install the metal or slate barrier. The site is covered with rubber. Without the sun, the area will be clear of raspberries.
-
To get rid of the berries, you will need to sow the area with another crop that develops a powerful root system and displaces other plants.
It may seem that mowing raspberries and cutting off shoots is a useless work, but this is not so. If young plants are often removed, the root will die over time. It is worth removing seedlings from the point of growth, and it is located at the very base of the plant, near the soil.
It is advisable to sprinkle the remaining rhizomes with a weed killer. You should be careful with it, because if it gets on the foliage of other crops, then these plants will suffer.
A good tool would be to apply mulch in the fall. Even a dense layer of leaves will suffocate the young shoots of raspberries, and they simply will not grow. This mulch will weaken the roots remaining in the ground, and they will lose the ability to sprout.
If, after a year, rare berry bushes begin to break through on the site, they are completely pulled out by the roots.Only repeated removal of the plant from the site helps to get rid of it forever.
There is a good homemade method for picking a plant off the ground. This is an acetic salt solution. Experts advise to carry out processing twice a year: at the end of the autumn period and immediately before winter. But, you need to understand that after such events, the sprayed soil will become unsuitable for further planting.
Such a solution will completely destroy the fertile layer, therefore, it is necessary to apply the agent after the digging has been carried out, or on the buds between the thickets of the bush.
There are several ways to prepare such a solution.
-
You will need to take a kilogram of salt, which is diluted in a bucket of water. It is best to use warm water to dissolve the salt faster. The raspberry tree is watered to a depth of 6 centimeters. On larger bushes, the salt concentration can be increased.
-
You need 500 ml of acetic acid, which is diluted in 5 liters of water. Water the raspberries to a depth of about 3 centimeters.
After processing, the area will need to be covered with slate, rubber or any other dense material. So easily you can kill not only young shoots, but also the roots. If it is planned to build a building on the treated area in the future, then you can simply sprinkle the soil with salt.
Its thickness should be 5 mm, otherwise there will be no sense.
There is another method by which you can get rid of raspberries - the use of herbicides. Such funds work at the molecular level, so they do not react with the soil. The active substance contained in the herbicide only affects the plant. It penetrates the foliage and stem deep into the roots and blocks further growth. Within 14 days, such a chemical agent will decompose and turn into water and gas.
This method involves minimal labor on the part of the gardener, but one approach is not enough. Processing is carried out several times per season. Not only shrubs are treated with the prepared solution, but also the ground around. Be sure to cut the raspberries at the root before the procedure. A concentrated solution is dripped onto the sections; you can use a syringe for this.
The comment was sent successfully.