How to properly dig the earth with a shovel?

How to properly dig the earth with a shovel?
  1. Correct technique
  2. Subtleties
  3. How to dig up an overgrown area?
  4. How to dig a hole?
  5. How to properly dig frozen ground?

Only at first glance it seems that digging with a shovel is a rather simple process, but, however, not fast. But actually it is not. The presence of aching calluses and pain in the lower back after working with a shovel is the result of a violation of the correct digging technique. This article will tell you about the rules for using a shovel and how to quickly dig a hole yourself and many other nuances.

Correct technique

It is necessary to dig correctly at least in order to make the whole process much easier and faster.

As a child, many have seen how to use a shovel. The basic movements remain the same, but you need to pay attention to one main point - you cannot lift the instrument with the ground using your wrists. You need to try to hook the end of the handle with your elbow, thereby giving an additional impulse, due to which the load on the back and joints of a person will decrease. Following this simple rule, you can dig up a large vegetable garden without any problems.

During the entire working process, the back should remain straight, and the center of gravity should be in the middle, otherwise in the morning you can wake up sick and weak.

The position of the leading hand can be alternately changed while maintaining the necessary balance.

This technique becomes especially useful and necessary for large-scale and long-term work, for example, when it is required to dig a garden or remove large amounts of snow in the winter season.

Subtleties

The most important nuance is the correct selection of the tool - you need to choose it yourself for yourself. If the shovel is too large and heavy, then subsequent back pain and pain throughout the body are inevitable. If the length of the cutting reaches the elbow when it is stuck into the ground by about 20-25 cm, then it is selected correctly and for the height of a person.

The bayonet of the tool should be sharp and well sharpened for easier penetration into the soil.

It is best to take not a square shovel, but a rounded one, since the latter option cuts through the ground better.

It is not necessary that the angle of the bayonet to the soil during penetration be straight - it all depends on the purpose of the digging. To loosen the soil, 45 degrees, shallow penetration and scrolling movements are enough. Right angle movements are best done when digging a trench or hole.

Most shovels can be sharpened easily with coarse sandpaper. There are other ways to sharpen a shovel: using a knife and a rasp.

How to dig up an overgrown area?

The instrument itself plays an important role in this matter. It is best to purchase a model made of titanium and a non-classical shape, the so-called miracle shovel. This tool is great for loosening or digging up the soil layer. It is an iron frame, on opposite sides of which there are pitchfork grids directed one to the other.

The operation of this simple device is as follows: some forks penetrate the ground, while the other is a lever for them. The frame serves as a support for two pairs of forks.

You can loosen the earth with a miracle shovel in much less time than a simple option. In addition, the advantage is the fact that when loosening the soil in this way, you can get rid of weeds.

Of the shortcomings, it is worth noting the following point: a miracle shovel can neither dig a hole nor process wetlands.

How to dig a hole?

This special digging technique is used by soldiers to dig trenches quickly and efficiently. They use a compact sapper shovel.

The basis of this technique is that you need to cut the soil of small thickness - 3-4 cm each. Such small cuts are easier to dig up and throw further than a full joint of the soil.

With this technique, you can work for several hours and dig more than one hole without much fatigue.

Any soil, including clay and peat, easily lends itself to this method of digging.

How to properly dig frozen ground?

It is no secret that domestic winters are quite harsh, and the land, like most water bodies, freezes to a considerable depth.

There are several ways to dig a hole out of frozen soil.

  1. The first and proven method is pretty easy to use, but it can be quite time consuming. Before digging, you need to make a fire in the place of the pit. After waiting for it to go out, you should start digging. After the top layer is removed, you need to build a fire again already in the hole and continue digging to the desired depth.
  2. Another proven method is the use of a jackhammer. If it is not possible to purchase a jackhammer, then you can rent it. With the help of a jackhammer, it is enough to remove only the upper frozen layer of the earth, and then you should continue to work with a shovel.
  3. The next way is to use a pickaxe. It is a hand-held percussion tool specially designed for tough and even rocky ground. But a pickaxe alone will not be enough - a shovel is needed.

The modern market for garden tools offers many different models of shovels: gardening, construction, loading and unloading. Each of the varieties has its own characteristic features that make this or that work much easier and faster.

In conclusion, it should be noted that most of the recommendations and rules can be used while working with a pitchfork. In some cases, they can also serve as a shovel, but with only one difference: if the shovel cuts the ground, then the pitchfork is more likely to break it off.

You can see how to properly dig the earth with a shovel in the video below.

no comments

The comment was sent successfully.

Kitchen

Bedroom

Furniture