All about worktop end strips

In this article, everything is written about the end strips for the table top: 38 mm, 28 mm, 26 mm and other sizes. The features of the connecting slotted profiles, black aluminum strips, the specifics of their installation are analyzed. You can figure out how to properly attach the end plate.

Countertops used in kitchens are mostly made from particle board. They are additionally coated with a material that increases the wear resistance of the surface. But the problem is that there is no such protection at the bottom and at the edges. If the lower part of the structure is still completely hidden from prying eyes, and it can be safely ignored, then it is almost impossible to do without protective end strips for the table top. Otherwise, a lot of dirt and dust will collect there; the effect of strong heating is also not worth ignoring.

Each plank has its own specific work profile. It is customary to distinguish end and docking (they are also slotted or, otherwise, connecting) modifications. The first type allows you to close insufficiently processed edges. Where there are end strips, they do not get to the cut:

• liquids, including water;

• condensate;

• spray.

End strips are considered universal, because one and the same look is placed on countertops of any format, even with pronounced curvilinear geometry. Installation is usually done with self-tapping screws. They are introduced through special holes prepared in advance. The second type of slats performs such an important task as decorating the junction of the two parts of the headset.

Usually an aluminum strip is used. Contrary to popular belief, it is by no means thicker than its steel counterpart. What's more, the slim appearance and resistance to food acids count for a lot. "Winged metal" is lighter than steel, which may not seem too significant, but savings in weight are never superfluous. The service life of aluminum is quite long and can be used almost indefinitely.

The thickness of the plank is directly related to its other dimensions. Here is an approximate match for several models:

• with a thickness of 38 mm - width 6 mm, height 40 mm and length 625 mm;

• with a thickness of 28 mm - width 30 mm, height 60 mm and depth 110 mm;

• with a thickness of 26 mm - 600x26x2 mm (products with a thickness of 40 mm are practically not produced in series, and they must be bought to order).

But to be limited only by size - that's not all. In order for the strip for the end of the countertop to perform its function clearly, attention must be paid to other subtleties. So, along with aluminum products, plastic structures can sometimes be used. But they are not durable enough and are easily damaged by sharp objects, therefore, such models can be chosen only as a last resort with an acute shortage of funds. Metal structures should ideally have a matte look so that any roughness is less noticeable; otherwise, it is enough to consult with the sellers or manufacturers of countertops.

However, the matter does not end with the right selection. It is very important to properly secure the purchased product. In most cases, such work is performed by the furniture makers themselves in production or during the assembly process. But sometimes, for reasons of economy, their services are refused.Or they forget to order the design of the butt end.

Or it eventually deteriorates and requires replacement. There is no need to be afraid of such work - it is quite within the power of the most ordinary people.... All that is required is a sealant and self-tapping screws of a certain section. Only in some cases, when there are no holes in the countertop itself, in general, or in those very necessary places, you have to drill it. One way or another, making sure that all the required holes are ready, apply the sealant; then it remains only to fasten the product with self-tapping screws and use it calmly.

Drilling in artificial or natural stone is done with a drill at the lowest speed.

Types and installation of planks in the video below.